1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
|
Rockchip SoC Image Signal Processing unit v1
----------------------------------------------
Rockchip ISP1 is the Camera interface for the Rockchip series of SoCs
which contains image processing, scaling, and compression funcitons.
Required properties:
- compatible: value should be one of the following
"rockchip,rk3288-rkisp1";
"rockchip,rk3326-rkisp1";
"rockchip,rk3399-rkisp1";
- reg : offset and length of the register set for the device.
- interrupts: should contain ISP interrupt.
- clocks: phandle to the required clocks.
- clock-names: required clock name.
- iommus: required a iommu node.
port node
-------------------
The device node should contain one 'port' child node with child 'endpoint'
nodes, according to the bindings defined in Documentation/devicetree/bindings/
media/video-interfaces.txt.
- endpoint(parallel):
- remote-endpoint: Connecting to a sensor with a parallel video bus.
- parallel_bus properties: Refer to Documentation/devicetree/bindings/
media/video-interfaces.txt.
- endpoint(mipi):
- remote-endpoint: Connecting to Rockchip MIPI-DPHY,
which is defined in rockchip-mipi-dphy.txt.
The port node must contain at least one endpoint, either parallel or mipi.
It could have multiple endpoints, but please note the hardware don't support
two sensors work at a time, they are supposed to work asynchronously.
Device node example
-------------------
isp0: isp0@ff910000 {
compatible = "rockchip,rk3399-rkisp1";
reg = <0x0 0xff910000 0x0 0x4000>;
interrupts = <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH 0>;
clocks = <&cru SCLK_ISP0>,
<&cru ACLK_ISP0>, <&cru ACLK_ISP0_WRAPPER>,
<&cru HCLK_ISP0>, <&cru HCLK_ISP0_WRAPPER>;
clock-names = "clk_isp",
"aclk_isp", "aclk_isp_wrap",
"hclk_isp", "hclk_isp_wrap";
power-domains = <&power RK3399_PD_ISP0>;
iommus = <&isp0_mmu>;
port {
#address-cells = <1>;
#size-cells = <0>;
/* mipi */
isp0_mipi_in: endpoint@0 {
reg = <0>;
remote-endpoint = <&dphy_rx0_out>;
};
/* parallel */
isp0_parallel_in: endpoint@1 {
reg = <1>;
remote-endpoint = <&ov5640_out>;
bus-width = <8>;
};
};
};
|
