/* * (C) Copyright 2011 * Jason Cooper * * Based on work by: * Marvell Semiconductor * Written-by: Siddarth Gore * * SPDX-License-Identifier: GPL-2.0+ */ #ifndef _CONFIG_DREAMPLUG_H #define _CONFIG_DREAMPLUG_H /* * FIXME: This belongs in mach-types.h. However, we only pull mach-types * from Linus' kernel.org tree. This hasn't been updated primarily due to * the recent arch/arm reshuffling. So, in the meantime, we'll place it * here. */ #include #ifdef MACH_TYPE_DREAMPLUG #error "MACH_TYPE_DREAMPLUG has been defined properly, please remove this." #else #define MACH_TYPE_DREAMPLUG 3550 #endif /* * Version number information */ #define CONFIG_IDENT_STRING "\nMarvell-DreamPlug" /* * High Level Configuration Options (easy to change) */ #define CONFIG_SHEEVA_88SV131 1 /* CPU Core subversion */ #define CONFIG_MACH_TYPE MACH_TYPE_DREAMPLUG /* * Commands configuration */ #define CONFIG_CMD_EXT2 #define CONFIG_CMD_FAT /* * mv-plug-common.h should be defined after CMD configs since it used them * to enable certain macros */ #include "mv-plug-common.h" /* * Environment variables configurations */ #ifdef CONFIG_SPI_FLASH #define CONFIG_ENV_IS_IN_SPI_FLASH 1 #define CONFIG_ENV_SECT_SIZE 0x10000 /* 64k */ #else #define CONFIG_ENV_IS_NOWHERE 1 /* if env in SDRAM */ #endif #ifdef CONFIG_CMD_SF #define CONFIG_HARD_SPI 1 #define CONFIG_KIRKWOOD_SPI 1 #define CONFIG_ENV_SPI_BUS 0 #define CONFIG_ENV_SPI_CS 0 #define CONFIG_ENV_SPI_MAX_HZ 50000000 /* 50 MHz */ #endif /* * max 4k env size is enough, but in case of nand * it has to be rounded to sector size */ #define CONFIG_ENV_SIZE 0x1000 /* 4k */ #define CONFIG_ENV_ADDR 0x100000 #define CONFIG_ENV_OFFSET 0x100000 /* env starts here */ /* * Default environment variables */ #define CONFIG_BOOTCOMMAND "setenv ethact egiga0; " \ "${x_bootcmd_ethernet}; setenv ethact egiga1; " \ "${x_bootcmd_ethernet}; ${x_bootcmd_usb}; ${x_bootcmd_kernel}; "\ "setenv bootargs ${x_bootargs} ${x_bootargs_root}; " \ "bootm 0x6400000;" #define CONFIG_EXTRA_ENV_SETTINGS \ "x_bootcmd_ethernet=ping 192.168.2.1\0" \ "x_bootcmd_usb=usb start\0" \ "x_bootcmd_kernel=fatload usb 0 0x6400000 uImage\0" \ "x_bootargs=console=ttyS0,115200\0" \ "x_bootargs_root=root=/dev/sda2 rootdelay=10\0" /* * Ethernet Driver configuration */ #ifdef CONFIG_CMD_NET #define CONFIG_MVGBE_PORTS {1, 1} /* enable both ports */ #define CONFIG_PHY_BASE_ADR 0 #endif /* CONFIG_CMD_NET */ /* * SATA Driver configuration */ #ifdef CONFIG_MVSATA_IDE #define CONFIG_SYS_ATA_IDE0_OFFSET MV_SATA_PORT0_OFFSET #endif /*CONFIG_MVSATA_IDE*/ #endif /* _CONFIG_DREAMPLUG_H */