This file contains information for VSC9953, a Vitesse L2 Switch IP which is integrated in the T1040/T1020 Freescale SoCs. About Device: ============= VSC9953 is an 8-port Gigabit Ethernet switch supports the following features: - 8192 MAC addresses - Static Address provisioning - Dynamic learning of MAC addresses and aging - 4096 VLANs - Independent and shared VLAN learning (IVL, SVL) - Policing with storm control and MC/BC protection - IPv4 and IPv6 multicast - Jumbo frames (9.6 KB) - Access Control List - VLAN editing, translation and remarking - RMON counters per port Switch interfaces: - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links) to FMan ports (FM1@DTSEC1 and FM1@DTSEC2) Commands Overview: ============= Commands supported - enable/disable a port or show its configuration (speed, duplexity, status, etc.) - port statistics - MAC learning - add/remove FDB entries - Port-based VLAN - Private/Shared VLAN learning - VLAN ingress filtering - Port LAG Commands syntax ethsw [port ] { enable | disable | show } - enable/disable a port; show a port's configuration ethsw [port ] statistics { [help] | [clear] } - show an l2 switch port's statistics ethsw [port ] learning { [help] | show | auto | disable } - enable/disable/show learning configuration on a port ethsw [port ] [vlan ] fdb { [help] | show | flush | { add | del } } - add/delete a mac entry in FDB; use show to see FDB entries; if [vlan ] is missing, VID 1 will be used ethsw [port ] pvid { [help] | show | } - set/show PVID (ingress and egress VLAN tagging) for a port ethsw [port ] vlan { [help] | show | add | del } - add a VLAN to a port (VLAN members) ethsw [port ] untagged { [help] | show | all | none | pvid } - set egress tagging mode for a port ethsw [port ] egress tag { [help] | show | pvid | classified } - configure VID source for egress tag. Tag's VID could be the frame's classified VID or the PVID of the port ethsw vlan fdb { [help] | show | shared | private } - make VLAN learning shared or private ethsw [port ] ingress filtering { [help] | show | enable | disable } - enable/disable VLAN ingress filtering on port ethsw [port ] aggr { [help] | show | } - get/set LAG group for a port => ethsw show Port Status Link Speed Duplex 0 enabled down 10 half 1 enabled down 10 half 2 enabled down 10 half 3 enabled up 1000 full 4 disabled down - half 5 disabled down - half 6 disabled down - half 7 disabled down - half 8 enabled up 2500 full 9 enabled up 2500 full =>